Alpha ESS SMILE-S6-HV Installation Manual page 6

SAFETY
DANGER
Danger to life due to electric shock when touching live system components
in case of a ground fault.
If a ground fault occurs, parts of the system may still be live. Touching live parts
and cables results in death or lethal injuries due to electric shock.
Disconnect the product from voltage sources and make sure it cannot be
reconnected before working on the device.
Touch the cables of the PV array on the insulation only.
Do not touch any parts of the substructure or frame of the PV array.
Do not connect PV strings with ground faults to the inverter.
DANGER
Danger to life due to high voltages on the Battery Pack
Lethal voltage is present at the pin connector for the power cable. Reaching into
the pin connector for the power cable can result in lethal electric shock.
Do not open the battery pack.
Do not wipe over the battery pack with a damp cloth.
Leave the protective caps on the pin connectors for the batteries power
connection until the inverter cables are connected to the battery pack.
Disconnect the product from voltage sources and make sure it cannot be
reconnected before working on the inverter or the battery pack.
WARNING
Risk of chemical burns from electrolyte or toxic gases
During normal operation, no electrolyte can leak from the battery pack and no
toxic gases can form. Despite careful construction, if the battery pack is
damaged or a fault occurs, it is possible that electrolyte may be leaked or toxic
gases formed.
Store the battery pack in a cool and dry place.
Do not drop the battery pack or damage it with sharp objects.
Only set the battery pack down on its back or its bottom, i.e., on the side with
the mounting lugs.
Do not open the battery pack.
Do not install or operate the battery pack in potentially explosive atmosphere
or areas of high humidity.
If moisture has penetrated the battery pack (e.g. due to a damaged
enclosure), do not install or operate the battery pack.
In case of contact with electrolyte, rinse the affected areas immediately with
water and consult a doctor without delay.
06 07
CAUTION
Risk of burns due to hot heatsink and housing
The heatsink and housing can get hot during operation.
During operation, do not touch any parts other than the cover of the inverter.
NOTICE
Damage to the inverter due to electrostatic discharge
Touching electronic components can cause damage to or destroy the inverter
through electrostatic discharge.
Ground yourself before touching any component.
NOTICE
Damage due to cleaning agents
The use of cleaning agents may cause damage to the product and its components.
Clean the product and all its components only with a cloth moistened with
clear water.
SAFETY