Alpha ESS SMILE-S6-HV Installation Manual page 18

MOUNTING
3. Place the battery's positioning paper plate against the wall, fit holes of the paper plate
named B1 with the bottom two holes, mark the positions of the drill holes named A1
and A2 on the paper plate.
4. Drill 6 holes on the wall with drill Φ10, insert 6 screw anchors into the drill holes.
5. Remove the wall bracket from the battery and attach the wall brackets of inverter and
battery to the wall using the screws with the tool of SW10 hexagon sleeve. Please use
a level to ensure that the wall bracket is horizontal.
6. Hold the inverter by using the handles at two sides, attach the inverter onto the wall
bracket tilted slightly downwards.
30
SW10
31
7. Tighten the wall bracket and the inverter with screw M6*16 (X 3) (tool: T20
screwdriver, torque: 3.0Nm).
8. Remove the small support parts of the inverter cover and the two screws will be used
to connect to grounding point .
9. Horizontally lift the battery by using the handles at two sides, fit the rectangular hole
on the hanging lug with the wall bracket's folding lug and shift it to the right so that the
folding lug will be inserted into the rectangular hole. If the inverter is not aligned with
the battery, please increase or decrease PC gaskets to adjust it.
MOUNTING