Using Tractor After Storage - Kioti Daedong EX35 Manual

8 EX35(C)/EX40(C)/EX45(C)/EX50(C)
-4
! ! ! ! !
CAUTION
To avoid injury:
Never clean the tractor body
while the engine is running.
Never run the engine in an en-
closed area without proper ven-
tilation system in order to pre-
vent poisoning by exhaust gas.
When storing the tractor, re-
move the key from the switch
and store it separately in order
to prevent an unauthorized per-
son from operating the tractor
and being injured.
IMPORTANT
When washing the tractor, be
sure to stop the engine. Allow
sufficient time for the engine to
cool before washing.
Cover the tractor after the muf-
fler and the engine have cooled
down.
USING TRACTOR AFTER
STORAGE
1. Check the tire air pressure and in-
flate the tires if they are low.
2. Install a fully charged battery.
3. Check the fan belt tension.
4. Check all fluid levels.
(engine oil, transmission/hydraulic
oil, engine coolant and any attached
implements.)
5. Remove grease from the exposed
cylinder rod.
6. Apply grease to the lubrication
points.
7. Remove the cover from the exhaust
pipe.
8. Depress the clutch pedal and dis-
engage the latch hook.
9. Get onto the tractor and start the
engine.
10. Check if the instrument panel and
all parts operate correctly while run-
ning the engine for a few minutes.
11. Drive the tractor outside and check
if it is operating properly. Park the
tractor outside and idle engine for
at least 5 minutes. Stop the engine
and visually inspect the tractor.
Check if there is leakage.
12. Start the engine, release the park-
ing brake, and check the brake con-
dition while driving forward. Adjust
the brake pedals if necessary.
13. Stop the engine and check for
leakage. Repair any part as
required.
! ! ! ! !
CAUTION
If the battery is not to be
removed, disconnect its nega-
tive terminal at least. The wir-
ing can be gnawed by rodents,
leading to a fire.