xFusion Digital Technologies FusionServer 5288 V7 Manual page 24

FusionServer 5288 V7 Server
Technical White Paper
Silkscreen
-
Issue 01 (2023-07-20)
Indicator
PSU indicator
UID indicator
Copyright © xFusion Digital Technologies Co., Ltd.
5 Hardware Description
Description
● Off: No power is supplied.
● Blinking green at 1 Hz:
– The input is normal, and the
server is in the standby state.
– The input is overvoltage or
undervoltage.
– The PSU is in deep hibernation
mode.
● Blinking green at 4 Hz: The firmware
is being upgraded online.
● Steady green: The input and output
are normal.
● Steady orange: The input is normal
but there is no output.
NOTE
The possible causes of no output are as
follows:
● Power supply overtemperature
protection
● Power output overcurrent or short-
circuit
● Output overvoltage
● Short-circuit protection
● Device failure (excluding failure of all
devices)
The UID indicator helps identify and
locate a device.
● Off: The device is not being located.
● Blinking or steady blue: The device is
being located.
NOTE
You can control the UID indicator status by
pressing the UID button or using the iBMC.
17