Advertisement
procedures which can only be completed with a Nice "ERA P" or "ERA W" transmitter with the s, n, t, PRG, ESC keys
GENERAL WARNINGS RELATING TO THE PROCEDURES
• Before starting any programming, move the awning to an intermediate position, away from the Up and Down limit switch-
es.
• All the programming procedures must be completed by selecting a single channel on the transmitter.
• If the programming transmitter controls multiple groups of screen motors, before sending a command requested by
the procedure, select the group to which the motor being programmed belongs.
• When the motor is powered up, if it makes 2 movements this means that: at least one transmitter has been memorised
and no limit switch has been programmed; if, on the other hand, it makes 1 movement this means that: no transmitter
has been memorised.
• When running a procedure, you can abort the procedure at any time by pressing ESC (on the back of the transmitter).
• When the Up and Down limit switches are not programmed, the awning can only be commanded in hold-to-run mode -
i.e. you must hold the button down until the awning reaches the desired position. The movement stops when you release
the button in any position.
• When the Up and Down limit switches have been programmed , the awning can be controlled by simply pressing and
releasing the buttons. Doing so starts the movement, which is stopped automatically by the system when the awning
reaches the programmed position.
• All procedures require you to use a transmitter memorised in "Mode I" (e.g., memorised with procedure A.1, B.1 or D.1).
A.1 - Memorising the FIRST TRANSMITTER (in "Mode I")
A
• This procedure must be used only for memorising the FIRST TRANSMITTER. If the motor does not perform the procedure, it means that one or more trans-
mitters are already memorised; therefore, to memorise further transmitters,m use the procedure described under section A.2 (motor configured for ONE-WAY
communication), B.3 (motor configured for TWO-WAY communication) or D.2 (motor configured for ONE-WAY communication and OLD generation transmitter lack-
ing the PRG and ESC keys).
• If all transmitters memorised in the motor are deleted, the first transmitter you memorise thereafter must be memorised with this procedure.
• If the installation has multiple motors, the procedure must be repeated for each motor separately.
• After memorisation, the raising and lowering direction of the awning is not yet associated with the s and t respective keys of the transmitter. This combination will
occur automatically when adjusting limit switches "0" and "1" (see procedure C.1); moreover, the rolling shutter will move in the "operator present" mode until the limit
switches are adjusted.
• If within the transmitter's range there are multiple powered up motors, to memorise the first transmitter in any one of them, it is necessary to disconnect the power
supply to all other motors and proceed as follows:
1
2
ON
Move the awning to
Switch on
a half-way position.
mains power,
–– GROUP "A" PROCEDURES ––
for motors configured for ONE-WAY communications
3
1
count 1 movement.
Hold down the but-
ton and
= 5 sec
3
PRG
release it after 5 sec-
onds;
MONO
end
PRG
release the button.
MONO
English – 8
Advertisement
