Advertisement
D.6 - MANUAL programming of the UP ("0") and DOWN ("1") limit switches
D
NOTES AND WARNINGS
• This procedure is obligatory only for awnings without a mechanical stop at the Up position.
• This procedure can be used if the limit switches have been programmed using the semiautomatic procedure (D7)".
• After the limit positions have been programmed, the awning can be controlled by simply pressing the appropriate buttons on the control unit. The awning will move
between the positions set with procedures D.6.1 and D.6.2.
D.6.1 - To program the UP limit switch ("0")
1
5
2
sec.
Hold down the
count 2 movements;
button and
3
5
2
sec.
Hold down the
count 2 movements;
button and
5
Regolare con
precisione la
quota del fine-
corsa "0"
Press the buttons until you reach the desired position.
Alternatively, for more accurate adjustment, run pro-
cedure D.2.
• Note – When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press
any keys and wait 60 seconds for the motor to perform 6 movements.
D.6.2 - To program the DOWN limit switch ("1")
1
5
2
sec.
Hold down the
count 2 movements;
button and
3
5
2
sec.
Hold down the
count 2 movements;
button and
5
Finely adjust-
ing the posi-
tion of limit
switch "1"
Press the buttons until you reach the desired position.
Alternatively, for more accurate adjustment, run pro-
cedure D.2.
• Notes – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements. • After the adjustments, the s key will command the Raising motion and the key t key will
command the Lowering motion. The awning/shutter will move within the limits constituted by the two limit switch heights.
2
release the button.
Hold down the but-
ton and
4
Command
an UP
movement
release the button.
Hold down the button and wait...
6
" 0 "
5
sec.
Hold down the
count 3 movements;
button and
2
release the button.
Hold down the but-
ton and
4
Command
an DOWN
movement
release the button.
Hold down the button and wait...
6
" 1 "
5
sec.
Hold down the
count 3 movements;
button and
5
4
sec.
count 4 move-
release the button.
ments;
... release the button as soon as the awning reaches
position "0" ( UP limit switch).
3
release the button.
5
4
sec.
count 4 move-
release the button.
ments;
... release the button as soon as the awning reaches
position "1" ( DOWN limit switch).
3
release the button.
MONO
3
" 0 "
end
3
" 1 "
end
5
5
English – 24
Advertisement
