Advertisement
D.2 - Memorising ANOTHER TRANSMITTER (second, third, etc.)
D
NOTES AND WARNINGS
•The motor configured to operate in ONE-WAY mode can memorise up to 30 transmitters.
• To run procedure D.2.1, you must have a new transmitter to memorise and an old previously memorised transmitter. The two transmitters must have the "PRG"
and "ESC" buttons (like "ERA P" and "ERA W" transmitters).
• To run procedure D.2.2 you must have a new transmitter to memorise, chosen from the "Nice Screen" catalogue , and an old previously memorised transmitter.
D.2.1 - To memorise the transmitter buttons in "Mode I" ("Standard mode")
• Procedure D.2.1 memorise all the new transmitter's buttons in "Mode I", with the same configuration as the old transmitter (for details about "Mode I" see par. 4.6.1).
1
= 8 sec
NEW
On the OLD transmitter: hold down the but-
ton and
3
(x 1)
NEW
On the NEW transmitter: press and
release the button (1 time);
D.2.2 - To memorise the transmitter buttons in "Mode II" ("Custom mode")
• Procedure D.2.2 memorise a single button on the new transmitter in Mode II; i.e. they associate with the button (chosen by the installer) one of the commands in the
motor's "list of commands" (for details on "Mode II" see section 4.6.1).
• Procedures D.2.2 memorise a single button. Repeat this operation to memorise another button.
• When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
NEW
On the NEW transmitter: hold down the but-
ton you want to memorise;
3
Select the desired
option and program
it as follows
On the OLD transmitter: press and release the button the number of times indicated in the option you have chosen;
3
7
n
sec.
after about 7 seconds, the motor performs a
number of movements equal to the number of
pulses entered.
21 – English
release it after 8 sec-
onds.
count 3 movements (= transmitter memorised). If
the system makes 6 movements (= memory locked or
full, transmitter not memorised).
= 8 sec
...
...
release it after 8 sec-
onds;
(x ...)
4 OPTIONS:
1 press = Open > Stop > Close > Stop > ...
2 presses = Open
3 presses = Close
OLD
4 presses = Stop
4
?
NEW
On the NEW transmitter: hold down the
same button you pressed in Step 1;
2
OLD
On the OLD transmitter: press and release the but-
ton (3 times), provided the button is memorised.
end
3
2
= 5 sec
OLD
On the OLD transmitter: hold down the
button and
= 5 sec
...
release it after 5
seconds;
MONO
3
(x 3)
release it after 5
count 4 movements.
seconds;
...
3
count 3 movements (= transmitter memo-
rised). If the system makes 6 movements (= mem-
ory locked or full, transmitter not memorised).
3
4
continues
end
Advertisement
