Advertisement
D.3 - Memorisation of a climate sensor connected via radio
D
NOTES AND WARNINGS
• To run this procedure you need the climate sensor you want to memorise, chosen from the "Nice Screen" catalogue, and an old transmitter memorised in Mode I
(see par. 4.6.1).
• When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
= 10 sec
P1
sensor
On the climate SENSOR: hold down
the yellow button "P1";
D.4 - TOTAL or PARTIAL deletion of memory
D
NOTES AND WARNINGS
• In order to carry out the following deletion procedures, the transmitter must be memorised in mode I.
• To change the motor's configuration (from TWO-WAY to ONE-WAY), after completing the "FULL deletion of the memory" procedure, it is necessary to switch the
motor off and then on again.
D.4.1 - Procedure run with a memorised transmitter
1
5
2
sec.
Press and release
count 2 movements;
the button (1 time);
3
5
3
sec.
Hold down the but-
count 3 movements;
ton and
5
...
Select one of the following potions and execute it:
• option A – delete the motor's ENTIRE memory
• option B – delete ALL memorised transmitters
• option C – delete ONE memorised transmitter
• option D – delete ALL positions ("0", "1", "H", etc.). Caution! – This deletion should only be performed if you wish reprogram the distances us-
ing a procedure different from the one used previously (e.g. you have used manual distance programming (D.6) and would now like to use the
semi-automatic procedure (D.7).
5
5
sec.
Hold down both but-
count 5 movements;
tons;
2
P1
OLD
release it after 10
On the OLD transmitter: press
seconds;
and release (3 times) any button.
2
release the button.
Hold down the but-
ton and
4
release the button.
Hold down the but-
ton and
end
5
release the buttons.
MONO
3
(x 3)
...
sensor
On the climate sensor: press and
release (1 time) the yellow button
"P1";
MONO
5
3
sec.
count 3 move-
ments;
5
3
sec.
count 3 movements;
5
...
.
(x 1)
3
P1
count 3 movements (= sen-
sor memorised). If the sys-
tem makes 6 movements (=
memory locked or full, sensor
not memorised).
3
release the button.
5
release the but-
ton.
end
5
count 5 movements;
end
English – 22
Advertisement
