Raising The Foot End - PARAMOUNT BED 7B01001000A3 Operator's Manual

1 BEFORE USING THE BED

Raising the foot end

You can change the angle of the leg section so that the foot end is raised.
[Foot end lowered state]
Leg section
[Foot end raised state]
<Switching method>
1.
10°
2.
3.
Lift up the leg
section end
Horizontal
Lift up the leg section
switching lever
35
Perform the knee up operation to raise the knee
section.
Holding both ends of the leg section, lift up the
leg section all the way.
The leg section switching lever locks and the foot
end will be in the raised state.
To lower the foot end, lift up the leg section
switching lever with one hand while supporting
the leg section end with your other hand, and
lower the leg section slowly.
* You can also lower the foot end by performing
the knee down operation while the foot end is
raised to lower the knee section to the lower
limit.
When the knee up operation is performed
again after lowering the knee section all
the way to the bottom, the foot end will be
in the lowered state.