Table of Contents
Advertisement
5 REFERENCE INFORMATION
Daily maintenance
WARNING
<Bed>
g When removing stains from parts
Perform steps 1 to 3 below.
1.
Wipe off stains with a cloth soaked in a neutral detergent diluted with water and wrung out well.
2.
Wipe off any residual detergent with a cloth soaked in water and wrung out well.
3.
Wipe away any leftover moisture with a dry cloth.
g When disinfecting parts
Use one of the disinfectants listed below at the specified concentrations by following the instructions in
the instruction manual for the disinfectant.
76.9% - 81.4%
Ethanol for disinfection
Up to 0.2%
Benzalkonium chloride (e.g., Osvan)
Up to 0.2%
Benzethonium chloride (e.g., Hyamine)
Up to 0.05%
Chlorhexidine gluconate (e.g., Hibitane)
Up to 1.0%
Sodium hypochlorite (e.g., Milton)
* It is recommended to disinfect the bed before another patient uses the bed.
CAUTION
Do not sterilize. The bed is not intended for sterilization and has not been tested for compati-
bility with healthcare sterilization systems including ozone, moist heat/steam, dry heat, eth-
ylene oxide vaporized Hydrogen peroxide and other chemical sterilizers. Exposure of the bed
to these processes may damage the bed and render it non-functional.
<Suitable products, etc.>
Follow the instructions described in the instruction manual supplied with the respective suitable product.
<Mattress>
Follow the instructions described in the instruction manual supplied with the mattress.
n To prevent accidents caused by incorrect operation, always disconnect
the power plug from the outlet before maintenance.
n Do not clean the bed by pouring water onto it. Short circuit and electric
shock may occur.
n Do not use volatile cleaning solutions (such as paint thinner, benzine, or
gasoline) or cresol. Discoloration or deterioration may result.
n Do not use disinfectants other than those listed above. Damage or
deterioration may result.
n Thoroughly wipe off parts with a damp cloth after using a neutral
detergent or sodium hypochlorite. Not doing so may cause cracking,
discoloration, or deterioration of the resin.
101
Advertisement
Table of Contents
