Table of Contents
Advertisement
2. Long-term storage and disposal
Long-term storage
The following precautions should be observed when the bed will not be in use for an extended period
of time.
n Turn off BED EXIT ALARM notification.
n Lay the head and knee sections flat.
n Lower the bed height to the minimum height.
n Do not place objects other than a mattress on the bed.
n Do not place any objects on the mattress.
n Avoid a location subject to high temperature or humidity, low temperature, dryness or excessive dust.
Store the bed at a temperature between -10˚C and 50˚C, humidity between 30% RH and 90% RH and
atmospheric pressure between 620 hPa and 1060 hPa.
n Do not lean the bed against a wall, but store it level on the floor.
n Be sure to disconnect the power plug from the outlet and bundle the power cable in a location where the
cable is not pinched or stepped on.
n Turn the battery off.
Product disposal
When the A6 Series has reached the end of its usable life, dispose of it according to the local rules and
regulations.
A gas spring attached to the head section is a part filled with high-pressure gas. When disposing of a gas
spring, dispose of it properly according to the following precautions.
• Drill a hole in the lowermost part of the gas spring cylinder to release all of the gas. (Refer to the figure
below.)
• Wear safety goggles and other protective equipment because chips and oil may fly off when releasing the
gas.
Drill
Gas spring
102
1.5 - 2 cm
Advertisement
Table of Contents
