Hard Reset To Ip Factory Defaults - Zennio ALLinBOX 1612 v2 User Manual

1.5 HARD RESET TO IP FACTORY DEFAULTS

The objective of the IP factory reset is to locate a device that is not accessible on a local
network due to an IP configuration loss. Once the device is accessible, it will be
necessary a new ETS download to introduce the desire IP configuration.
By pressing the "IP Factory Reset" button for three seconds:
The device will adopt an IP address via the DHCP server.
➢ If the DHCP client does not obtain a valid IP address (after several
attempts), then the device will be assigned an IP address via the AutoIP
(APIPA)
The factory reset indicator LED will light up in red.
If a second-long press is made on the "IP Factory Reset" button
The device will adopt a static IP address.
➢ If "Use a static IP address" has been chosen on the ETS configuration, the
device will have the configured IP.
The factory reset led will light up in green.
➢ On the other hand, if on the ETS configuration "Obtain an IP address
automatically" has been chosen, the device will obtain an IP by means of
AutoIP (APIPA).
The factory reset indicator LED lights up in yellow.
The factory IP setting and the colour of the factory reset LED will remain until the device
is restarted.
The following table summarizes the above:
Press
st
1 long press
(3s)
nd
2 long
1
Random static IP configuration in the range 169.254.1.0 - 169.254.254.255
https://www.zennio.com
1
protocol.
ETS Configuration
Obtain an IP automatically
Use a static IP address
Obtain an IP automatically
ALLinBOX 161
IP Configuration
IP obtained by DHCP.
(If a valid IP is not obtained →
IP by APIPA)
IP obtained by APIPA
Technical Support: https://support.zennio.com
/ 88 / 46 / Hospitality
LED
Red
Yellow
11