YASKAWA Varispeed G7 Series Instruction Manual page 66

 Straight Solderless Terminals for Signal Lines
Models and sizes of straight solderless terminal are shown in the following table.
Wire Size mm
0.25 (24)
0.75 (18)
1.25 (16)
Wiring Method
Use the following procedure to connect wires to the terminal block.
1. Loosen the terminal screws with a thin-slot screwdriver.
2. Insert the wires from underneath the terminal block.
3. Tighten the terminal screws firmly.
Strip the end for
7 mm if no sol-
derless terminal
is used.
-30
2
Table 2.10 Straight Solderless Terminal Sizes
2
Model
(AWG)
AI 0.25 - 8YE
0.5 (20) AI 0.5 - 8WH
AI 0.75 - 8GY
AI 1.5 - 8BK
2 (14) AI 2.5 - 8BU
Fig 2.15 Straight Solderless Terminal Sizes
Thin-slot screwdriver
Solderless terminal or wire
without soldering
Wires
Fig 2.16 Connecting Wires to Terminal Block
d1 d2 L
0.8 2 12.5
1.1 2.5 14
1.3 2.8 14
1.8 3.4 14
2.3 4.2 14
d1
d2
Blade of screwdriver
Control circuit
terminal block
Blade thickness: 0.6 mm max.
Manufacturer
Phoenix Contact
3.5 mm max.