YASKAWA Varispeed G7 Series Instruction Manual page 529

User Constants
* 15.If the setting is 0, the axis will accelerate to the specified speed for the specified acceleration time (C1-01 to C1-08).
* 16.Applicable for G7-Series Inverters with software versions PRG 1038 and later.
* 17.Applicable for G7-Series Inverters with software versions PRG 1034 and later.
* 18.Applicable for G7-Series Inverters with software versions PRG 1039 and later.
* 19.If a current exceeding 110% of the Inverter rated current flows through the unit, the carrier frequency will automatically decrease and electromagnetic noise will
occur.
* 20.This setting is for software versions PRG 1040 and later. The factory setting with software versions PRG 1039 and earlier depends on the Inverter capacity.
10
41
10-