Lenovo 7D7A Manual page 99

• FQXSPPU2006I: [ProcessorElementName] has Recovered from FRB3 condition.
This message is for the use case when an implementation has detected a Processor Recovered - FRB3
condition.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - CPU
SNMP Trap ID: 40
CIM Prefix: PLAT CIM ID: 0049
User Action:
Information only; no action is required
• FQXSPPU2007I: The System [ComputerSystemElementName] has detected a POST Error
deassertion.
This message is for the use case when an implementation has detected that Post Error has deasserted.
Severity: Info
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - CPU
SNMP Trap ID: 40
CIM Prefix: PLAT CIM ID: 0185
User Action:
Complete the following steps:
1. If the DIMM configuration was changed prior to this failure verify that the DIMMs are installed in the
correct population sequence.
2. RESEAT the DIMM that failed POST memory test and the DIMMs on adjacent slots if populated. Boot
to F1 setup and enable the DIMM. Reboot the system.
3. If the DIMMs have been upgraded just prior to the issue than update uEFI to the latest version.
4. If the problem persists, collect Service Data logs.
5. Contact Lenovo Support.
• FQXSPPU2008I: [ProcessorElementName] has been Enabled.
This message is for the use case when an implementation has detected a Processor has been Enabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0060
User Action:
Information only; no action is required
• FQXSPPU2009I: [ProcessorElementName] has Recovered from a Configuration Mismatch.
This message is for the use case when an implementation has Recovered from a Processor Configuration
Mismatch.
Severity: Info
.
Chapter 2 XClarity Controller events
95