Lenovo 7D7A Manual page 148

Table 3. Events organized by severity (continued)
Message String
Event ID
FQXSFIO0006I An inter-board UPI has been disabled on the link between processor
[arg1] port [arg2] and processor [arg3]port [arg4] because of UPI
topology downgrade.
FQXSFIO0015I IFM: System reset performed to reset adapters.
FQXSFIO0018I IFM: Configuration too large for compatibility mode.
FQXSFIO0020J PCIe Isolation has occurred in PCIe slot [arg1]. The adapter may not
operate correctly.
FQXSFIO0021I PCIe DPC software triggering occurred in physical [arg1] number
[arg2].
FQXSFIO0027I The Bus:[arg1] Device:[arg2] Fun:[arg3] is attempted to boot PXE.
FQXSFMA0001I DIMM [arg1] Disable has been recovered. [arg2]
FQXSFMA0002I The uncorrectable memory error state has been cleared.
FQXSFMA0006I [arg1] DIMM [arg2] has been detected, the DIMM serial number is
[arg3].
FQXSFMA0007I [arg1] DIMM number [arg2] has been replaced. [arg3]
FQXSFMA0008I DIMM [arg1] POST memory test failure has been recovered. [arg2]
FQXSFMA0009I Invalid memory configuration for Mirror Mode has been recovered.
[arg1]
FQXSFMA0010I Invalid memory configuration for Sparing Mode has been recovered.
[arg1]
FQXSFMA0011I Memory population change detected. [arg1]
FQXSFMA0012I The PFA of DIMM [arg1] has been deasserted.
FQXSFMA0013I Mirror Fail-over complete. DIMM [arg1] has failed over to to the
mirrored copy. [arg2]
FQXSFMA0014I Memory spare copy initiated. [arg1]
FQXSFMA0015I Memory spare copy has completed successfully. [arg1]
FQXSFMA0026I DIMM [arg1] Self-healing, attempt post package repair (PPR)
succeeded at Rank [arg2] Sub Rank [arg3] Bank [arg4] Row [arg5] on
Device [arg6]. [arg7]
FQXSFMA0027I Invalid memory configuration (unsupported DIMM Population)
recovered.
FQXSFMA0029I The PFA of DIMM [arg1] has been deasserted after applying PPR for
this DIMM. [arg2]
FQXSFMA0030I A correctable memory error has been detected on DIMM [arg1]. [arg2]
FQXSFMA0046I DIMM [arg1] is Intel Optane PMEM and its volatile or non-volatile
capacity will be inaccessible because that configuration mode is not
supported on current platform.
FQXSFMA0052I DIMM [arg1] has been disabled due to the error on DIMM [arg2].[arg3]
FQXSFMA0053I DIMM [arg1] re-enabled due to memory module combination
updating.
144
ThinkSystem ST650 V3 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational