Table of Contents
Advertisement
2. Check the Lenovo Support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
3. Check the system spec to make sure that the PCIe device or NVME disk is installed in the compatible
PCIe slot or bay and a compatible cable is used. If not, performance of this device might be
impacted.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFIO0024I: An error has been detected by the IEH on processor [arg1]. The type of IEH is
[arg2]. The index of the IEH is [arg3]. The value of IehErrorStatus register is [arg4]. Please check
error logs for additional downstream device error data.
Severity: Warning
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFIO0024J: PCIe Link Training Failure has occurred in physical [arg1] number [arg2].
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable device driver, firmware update, version of service
information for this product or other information that applies to this error. Load new device driver and
any required firmware updates.
2. If this device and/or any attached cables were recently installed, moved, serviced or upgraded.
a. Reseat adapter or disk and any attached cables.
b. Reload Device Driver.
c. If device is not recognized, reconfiguring slot to lower speed may be required. Gen1/Gen2/Gen3
settings can be configured via F1 Setup -> System Settings -> Devices and I/O Ports ->PCIe
Gen1/Gen2/Gen3/Gen4 Speed Selection, or the OneCLI utility.
d. If a PCIe error has also been reported on a second slot within the same node, please ensure steps
a, b, and c above are also performed for that adapter or disk before proceeding.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFIO0024M: An error has been detected by the IEH on processor [arg1]. The type of IEH is
[arg2]. The index of the IEH is [arg3]. The value of IehErrorStatus register is [arg4]. Please check
error logs for additional downstream device error data.
Severity: Error
User Action:
Complete the following steps:
1. Check Lenovo Support site for an applicable service bulletin or firmware update for the system or
adapter that applies to this error.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFIO0025I: An error has been detected by the IIO on processor [arg1]. The index of the IIO
stack is [arg2]. The type of IIO Internal Error is [arg3]. Please check error logs for additional
downstream device error data.
162
ThinkSystem ST650 V3 Messages and Codes Reference
Advertisement
Table of Contents
