Lenovo 7D7A Manual page 109

Automatically notify Support: No
Alert Category: System - Power On
SNMP Trap ID: 24
CIM Prefix: PLAT CIM ID: 0107
User Action:
Replace hard disk drive at the next maintenance period.
• FQXSPPW2009I: Power supply [arg1] in the enclosure/chassis (MTM-SN: [arg2])has been removed.
This message is for the use case when an implementation has detected a Power Supply has been
removed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: PLAT CIM ID: 0085
User Action:
Information only; no action is required.
• FQXSPPW2010I: [PowerSupplyElementName] has recovered from an error during power down.
This message is for the use case when an implementation has detected a Power Unit that encountered a
power down error recovery.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0111
User Action:
Information only; no action is required
• FQXSPPW2011I: [PowerSupplyElementName] power was restored.
This message is for the use case when an implementation has detected a power was restore to the Power
Unit.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0113
User Action:
Information only; no action is required
• FQXSPPW2012I: Soft power control working for [PowerSupplyElementName].
This message is for the use case when an implementation has detected a Power Unit that has recovered
from soft power control failure.
Severity: Info
.
Chapter 2 XClarity Controller events
105