Lenovo 7D7A Manual page 107

2. Check the power adapter max rate and power capping policy. If the required power resource is not
met, change the power adapter or modify power capping mechanism.
• FQXSPPW2001I: [PowerSupplyElementName] has been removed from container
[PhysicalPackageElementName].
This message is for the use case when an implementation has detected a Power Supply has been
removed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: PLAT CIM ID: 0085
User Action:
Complete the following steps:
1. Ensure one or more DIMMs are installed in the server.
2. Resolve existing memory errors if they are present.
3. If no memory fault is recorded in the logs,verify that all DIMM connectors are enabled using the Setup
utility or the OneCLI utility.
4. Reseat all DIMMs ensuring that DIMMs are installed in the correct population sequence, according to
the service information for this product.
5. Clear CMOS memory on system board. Note that all firmware settings will revert to the defaults.
6. Reflash UEFI firmware.
7. If problem persists, collect Service Data log.
8. Contact Lenovo Support.
• FQXSPPW2003I: Failure no longer predicted on [PowerSupplyElementName].
This message is for the use case when an implementation has detected a Power Supply failure is no
longer predicted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Power
SNMP Trap ID: 164
CIM Prefix: PLAT CIM ID: 0089
User Action:
Information only; no action is required
• FQXSPPW2004I: [PowerSupplyElementName] has returned to a Normal Input State.
This message is for the use case when an implementation has detected a Power Supply that has input
that has returned to normal.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0099
.
Chapter 2 XClarity Controller events
103