Lenovo 7D7A Manual page 121

SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0179
User Action:
Information only; no action is required
• FQXSPSE0000F: The Chassis [PhysicalPackageElementName] was opened.
This message is for the use case when the Chassis has been opened.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: PLAT CIM ID: 0004
User Action:
The chassis is either opened or is not properly sealed, please ensure the chassis is installed well.
• FQXSPSE0001I: The Computer System [ComputerSystemElementName] has detected a secure
mode violation.
This message is for the use case when an implementation has detected a Secure Mode Violation.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0022
User Action:
Complete the following steps until the problem is solved:
1. Check the event log of XClarity Controller (XCC) for any fan- or cooling-related issues.
2. Make sure that the airflow at the front and rear of the chassis is not obstructed and that fillers are in
place,clean, and correctly installed.
3. Make sure that the room temperature is within operating specifications.
4. Make sure that the microprocessor 1 heat sink is securely installed.
5. Make sure that the microprocessor 1 heat sink is installed correctly and the thermal interface is
correctly applied.
6. (Trained technician only) Replace the system board.
• FQXSPSE0002I: The Computer System [ComputerSystemElementName] has detected a pre-boot
user password violation.
This message is for the use case when an implementation has detected a Pre-boot user password
violation.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0024
.
Chapter 2 XClarity Controller events
117