Lenovo 7D7A Manual page 36

SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0145
User Action:
Information only; no action is required.
• FQXSPCN4003I: Remote Control session started by user [arg1] in [arg2] mode has been closed.
Remote Control session closed
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0194
User Action:
Information only; no action is required.
• FQXSPDA0001I: The Power Button [ButtonElementName] has been pressed.
This message is for the use case when an implementation has detected a Power Button was Pressed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0248
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot system.
3. If problem persists, collect Service Data log.
4. Contact Lenovo Support.
• FQXSPDA0002I: The Sleep Button [ButtonElementName] has been pressed.
This message is for the use case when an implementation has detected a Sleep Button was Pressed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0250
User Action:
Information only; no action is required.
• FQXSPDA2000I: The System [ComputerSystemElementName] has detected a POST Error
deassertion.
This message is for the use case when an implementation has detected that Post Error has deasserted.
32
ThinkSystem ST650 V3 Messages and Codes Reference