Diagnostic Tests - Rimage Professional Endeavor User Manual

Diagnostic Tests

01 – Cycle Outputs Diagnostic
This test runs discs from the supply bin and places a disc in tray #1, the next disc into
tray #2, and continues through tray #5, and then the output bin. Once the output
trays are filled, the rest of the discs are placed in the output bin. The process stops
when the supply bin is empty or the user presses the operator button. Place six discs in
the supply bin to run one disc to each output tray and output bin.
Press the operator button once to stop the test.
02 – Cycle Media Diagnostic
This test has three modes depending on where a disc is placed or not placed:
•
Cycle a disc from recorder
• Cycle disc from supply bin
•
Burn-in mode (no disc in the supply bin)
Cycle a Disc from Recorder
The printer must be aligned before running this test.
1. Open the recorder drawer by pressing the recorder's button.
2. Place a disc on the recorder drawer.
3. Select Diagnostic #2.
The process starts by detecting what elements (printer, or recorder) are in the
autoloader. It moves the lift arm down to the recorder, and then moves the arm to the
top of the lift. Opens the print drawer and closes it to see if there is a disc in the
printer. The lift arm moves down to the recorder and retrieves the disc. The print
drawer opens and the lift arm places the disc on the print drawer. The drawer closes
and reopens, and the lift arm retrieves the disc. The lift arm moves the disc to the
recorder and the cycle repeats until the operator button is pressed. Once the operation
has stopped, the disc is moved to output tray #1.
Cycle Disc from Supply Bin
The printer must be aligned before running this test.
1. Place a disc on the recorder drawer.
2. Select Diagnostic #2.
The process starts by detecting what elements (printer, or recorder) are in the
autoloader. It moves the lift arm down close to the supply bin, and then moves the arm
to the top of the lift. Opens the print drawer and closes it to see if there is a disc in the
printer. The lift arm moves down to the supply bin and retrieves the disc. The print
drawer opens and the lift arm places the disc on the print drawer. The drawer closes
and reopens, and the lift arm retrieves the disc. The lift arm moves the disc to the
supply bin again and the cycle repeats until the operator button is pressed. Once the
operation has stopped, the disc is moved to output tray #1.
Burn-in Mode
1. Close the recorder and print drawers if they are currently open.
24