Chapter 4 - Diagnostics And Error Messages; Introduction; Starting Diagnostics; Selecting A Diagnostic Test - Rimage Professional Endeavor User Manual

Chapter 4 - Diagnostics and Error Messages

Introduction

This chapter provides Endeavor diagnostic testing and error message information. The
Button Diagnostics allows you troubleshoot the Endeavor autoloader and components.
The Button Diagnostics include:
Diagnostic Test
01 – Cycle Outputs Diagnostic
02 – Cycle Media Diagnostic
03 – Calibrate Diagnostic
04 – Jog Lift Diagnostic
05 – Solenoid Test Diagnostic
06 – Lift Home Diagnostic
07 – Gripper Media Diagnostic

Starting Diagnostics

If the autoloader is connected to the Control Center and the Production Server is
running, there is a carrot symbol '^' on the upper right corner of the LCD Display.
1. Press and hold the operator button about eight seconds and release the
operator button when the display panel shows:
"BUTTON DIAGNOSTICS"
The operator panel shows "01 CYCLE OUTPUTS DIAGNOSTIC".
2. Go to "Selecting a Diagnostic Test" section.

Selecting a Diagnostic Test

Press the operator button the number of times of the test number and hold on the last
press to start the selected test. As you press the operator button, the panel shows the
test number and name. To display each diagnostic test number and name, press the
operator button at a slow rate just enough to read each test but do not hold down the
button too long, otherwise the test starts. After a short time, the operator panel
returns to test 01.
If you have lost your count in selecting a test, just release the button and the operator
panel returns to the first test.

Exiting Diagnostic Test

If an error message displays, locate the problem and fix any issues. Press the operator
button to exit the error message.

Exiting Diagnostic Mode

See test
14 – Exit Test Mode Diagnostics
Page Diagnostic Test
24 08 – Door Open Diagnostic
24 09 – Output Tray 1 Diagnostic
25 10 – Output Tray 2 Diagnostic
26 11 – Output Tray 3 Diagnostic
26 12 – Output Tray 4 Diagnostic
26 13 – Output Tray 5 Diagnostic
27 14 – Exit Test Mode Diagnostics
on page 28.
23
Page
27
27
28
28
28
28
28