MECHANICAL INSTALLATION
3.4.2 Installation instructions for flat rear heat sink
ATTENTION
3.4.3 Dimensions central heat sink
3.4.3.1 Air heat sink
All manuals and user guides at all-guides.com
Overheating of the device.
Never operate flat rear devices without main cooler.
► Select suitable cooling surfaces (e.g. water heat sink, ribbed heat
sink, machine base).
► Screw the flat rear of the devices to the cooling surface.
► Ensure good thermal conductivity (e.g. thermal paste)
► The machine builder is responsible for the cooling of the units.
Heat-conducting paste
Information about the correct application of the heat-conducting paste are
available at
www.keb.de
under the search term "Heat-conducting paste".
Select correct flow temperature for liquid coolers
► The flow temperature must be choose in such a way, that no mois-
ture condensation occurs.
Central heat sink for air-cooling upon request.
31