Nexcom VMC 100 Series User Manual page 19

Chapter 1: Product Introduction
I/O Interface-Rear
• 1x 5pin circular connector for Power/Ignition input
• 1x RJ45 for LAN
• 1x RJ45 for full RS-232 with 0V/5V/12V power supply (0.5A)
• 1x DB9 (Male) for
RX/TX or RS-485
2x CAN Bus 2.0
• 1x DB15 (Female) for
GPS dead reckoning interface (optional)
3x GPO, 3x GPI
Communication Module
• 1x Onboard GPS module
• 1x WLAN or Bluetooth module for optional
• 1x WWAN module for optional
Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user's self configuration
• Power on/off ignition, software detectable
Operating System
• Linux Ubuntu (kernel V3.2.0)
Operating System
• Operating temperatures: Ambient with air -20°C to 70°C
• Storage temperatures: -30°C to 80°C
• Relative humidity: 10% to 90% (non-condensing)
Copyright © 2014 NEXCOM International Co., Ltd. All rights reserved
• Vibration (random) : 3g @5~500Hz
• Vibration:
Operating: MIL-STD-810G, 514.6 Procedure 1, Category 4
Storage: MIL-STD-810G, 514.6 Procedure 1, Category 24
• Shock:
Operating: MIL-STD-810G, Method 516.6, Procedure I, trucks and
semi-trailers= 20g
Crash hazard: MIL-STD-810G, Method 516.6, Procedure V, ground
equipment= 75g
Power Design & Protection
• Load dump and inductive load protection
• Cold cranking protection
• Transient voltage protection
• Electrostatic discharge protection
Standards/Certifications
• EMC
-
CE, FCC class B
• Power
-
SAE J1113
-
SAE J1455
-
ISO 7637-2
• Safety
-
EN 60950-1 LVD
5
VMC 100/1100 Series User Manual