Front Door - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

Panel Installation

FRONT DOOR

Once the backbox of an Notifier INSPIRE E10 / E15 panel
is secured to a wall surface or semi flush mounted to a
wall, the Front Door can be attached to the backbox using
two quick-release-type hinges.
FITTING THE FRONT DOOR
To fit the front door, carefully line up the two hinges with
the enclosure-mounted hinge plates and proceed as
follows:
01 Locate the pillar (A) and spring-loaded catch plate

(B) with the front
plate.
02 With each hinge positioned as described, push the
back part of the hinge assembly firmly towards the
enclosure side wall until each spring-loaded catch
engages the rear rebate slot
a sudden 'snapping' action).
03 Connect the cable to CPU module and secure the
Earth wire from the backbox to the front door spade.

A
B
36

and rear rebates on the hinge

(this is confirmed with


REMOVING THE FRONT DOOR
01 Ensure Mains and Battery supplies are powered
down.
02 First, disconnect the cable from the CPU Module
and disconnect the Earth wire from the Front
door.
03 To release the door hinges, locate the spring-
loaded tab at the far end of the hinge assembly
(for clarity, the illustrations show the hinge as
it would appear looking from the inside of the
backbox).
04 While supporting the door, carefully pull the tab

outwards, i.e. away from the enclosure wall
until the hinge disengages the rear rebate slot of
the enclosure-mounted hinge plate.
05 Repeat this procedure for the second hinge and
release the door.
06 Store the door safely until required for refitting.
