Id²Net Network Module - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

Panel Installation
ID²NET NETWORK MODULE
1 -
2 -
3 -
4 RS485 #B Pin B
5 RS485 #B Pin A
1 2 3 4 5
6 7 8 9 10
6 -
7 -
8 -
9 RS485 #A Pin B
10 RS485 #A Pin A
ID2NET NETWORK
The ID²Net Network Module (HOP-631-100)
provides the isolated RS485 ports for a copper
network of INSPIRE panels. The module has
provision for conversion to Optical Fibre using plug-
in adaptors. Any combination of RS485 and Optical
Fibre is possible.
ID²NET Network module is colour coded Yellow
†
Dimensions H-130 mm x W-28 mm x D-117 mm
†
Copper connection to terminal blocks
†
Two isolated RS-485 ports are available as
†
standard
56
NET
ID2NET
Yellow
Optional plug-in adapters to convert to Optical Fibre
†
Any combination of RS-485 / Optical Fibre allowed
†
Module can be given a 40 character software label for
†
display on panel HMI
COPPER NETWORK CABLE
See approved lists of cables used for the wiring of
ID2NET Copper Network loop.
MULTI MODE FIBRE NETWORK CABLE
See approved list of fibre cable used for the wiring of
ID2NET Fibre Network loop.
INDICATORS
Green LED
†
Lit - Power On, Unlit - Power Off
Blinking - when registration, Initialisation or upgrade
process is active.
Yellow LED
†
Lit - Common fault at module, Unlit - No fault