Front Panel Led Indications - Honeywell SMX-AUS User Manual

User's Guide SMX-AUS

5.2 Front Panel LED Indications

The following table provides the details of the LED indications on the Panel:
Indicator Color Function
ALARM ROUTING ACTIVATED Red
FIRE Red
FAULT Yellow The LED flashes when the panel has detected a fault.
SUPERVISORY Yellow The LED flashes when the panel has detected a supervisory
DISABLED Yellow Part of the system, either input or output, has been
TEST Yellow The system is in the test mode. The screen shows which zones
ALARM SILENCED Yellow The sounder outputs are silenced.
SYSTEM FAULT Yellow The CPU has reset, or a system fault has occurred.
DELAY Yellow This indicates that the system is operating with delays to
SEVERAL ALARMS Red
POWER Green STEADY: Indicates presence of power (either AC mains
12
The Red LED flashes when the Alarm Relay on the Relay I/O
Card is activated in fire condition. The LED illuminates
steadily after the alarm feedback input is received from the
customer's Brigade interface.
The LED flashes when the panel has detected a fire alarm
condition.
The LED illuminates steadily after the alarm is
acknowledged using SILENCE BUZZER button.
The LED illuminates steadily after the fault is
acknowledged using SILENCE BUZZER button.
condition.
The LED illuminates steadily after the supervisory signal is
acknowledged using SILENCE BUZZER button.
disabled manually by the user.
are being tested.
the outputs and the delays are active.
The indicator shows when there are more than three
alarms. You can scroll up and down the list to see details of
the alarms.
and/or batteries).
To Clear the Indication
Correct the condition causing the alarm and then perform
Silence Alarm followed by panel reset.
Correct the condition causing the alarm and then perform
Silence Alarm followed by panel reset.
Correct the condition causing the fault.
For system faults, correct the problem and then perform a
panel reset.
Undo the activity, which caused the supervisory condition.
Re-enable the zones or devices. Refer to Disablement
Function.
After the test is completed, cancel or stop the test mode.
Correct the alarm condition and then perform a panel reset.
Press SILENCE / RESOUND again to reactivate the
sounders.
Correct the problem (if applicable). Then perform a panel reset.
The delays may be disabled.
Correct the condition causing the alarms and then perform
Silence Alarm followed by panel reset.
Not applicable.
NS-MN-0032 / 11.2020