Surface Mount - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

Panel Installation

SURFACE MOUNT

A Notifier INSPIRE E10/E15 panel can be surface mounted onto a flat wall using suitable fixtures and fittings,
whilst considering the weight of a fully assembled panel with batteries, see Technical Data for weight information.
As a general recommendation for types of wall surfaces ensure assessments are made and suitable fixtures and
fittings are used to hold the panel assembly.
Using the drill template supplied
type. All fixing points must be
of the E10 or E15 backbox. Use 50 mm long x 5 mm diameter screws
a
E10
a

a
32
The mounting of panel backbox shown below is to

mark the required holes

used. Drill and dowel
a
178mm 202mm
a
(E15)
442mm
364mm
(E10) (E10)
10U ENCLOSURE
364mm
15U ENCLOSURE
a
onto the wall surface depending on enclosure

the fixing holes. Fit the required spacers

to secure the backbox to wall.

a
E15
a
a
E10
a concrete block wall

x 2 (E10)
x 3
x 3 (E15)


25A
Fuse
.

to the back