Cable Length And Label; Terminal Number Label - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

CABLE LENGTH AND LABEL


Each incoming wire

(not supplied). The Label tag must be sticky on one
side and must be marked with terminal markings and

applied to each wire . The marking will assist the
engineer when making the connection to respective
terminal block on the module carrier.
Where cables are not required to be connected to
terminal block until later, then leave 500mm tail wire
length for E15 panel and 300mm tail wire length for
E10 panel.

Loop Out +ve
.
Notifier INSPIRE E10/E15 Control Panels - Installation instructions
must be fitted with a Label tag




TERMINAL NUMBER LABEL


Take one strip of label
separate (1-5) and (6-10)

labels as illustrated and
Module terminal blocks.

1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
. Cut the label in half to

. Stick the two strips of
.
Repeat for all other
1 2 3 4 5
6 7 8 9 10



1 2 3 4 5
6 7 8 9 10
43