Serial Communication Interface Module - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

SERIAL COMMUNICATION
INTERFACE MODULE
1 Aux. DC OUT +24 V
2 Aux. DC OUT GND
3 CH1 ISO GND
4 CH1 RS485 B
5 CH1 RS485 A
1 2 3 4 5
6 7 8 9 10
6 CH2 RS232 CTS
7 CH2 RS232 RTS
8 CH2 ISO GND
9 CH2 RX/B
10 CH2 TX/A
COMM Serial
The Serial Communication Interface Module (HOP-
405-100) provides an RS485 port and a configurable
RS232 / RS485 port, with an auxiliary 24V DC supply.
The module runs proprietary serial protocol 'Notifier
TPP' for communication with external equipment, like
legacy Notifier repeat / mimic panel, Pager and Serial
Printer.
Use only a recommended cable for wiring external
circuits to the RS232/485 ports, making sure the cable
length of 15 m/1.2 km respectively is not exceeded.
Notifier INSPIRE E10/E15 Control Panels - Installation instructions
COM
SERIAL
White
Serial Communication Module is colour coded White
†
Dimensions H-130 mm x W-28 mm x D-117 mm
†
Monitors communication faults
†
Module can be given a software label for
†
identification to display on panel HMI
Line 1 (CH1) has interface type RS485
†
this line can be given a software label
y
Incoming operation can be set to allow or forbid
y
Backup Fire Event can be set or unset
y
System Fault Event can be set to allow or forbid
y
Third party protocol or EDP
y
Line 2 (CH2) has interface type RS485 or RS232
†
this line can be given a software label
y
set to Third party protocol or EDP
y
An Output gives 24 V DC ± 5% maximum.
†
Current configurable to 0.5A, 1A, 1.5A and 2A
2 A maximum shared between all Modules in the
panel
State of Auxiliary Output On / Off
†
INDICATORS
Green LED
†
Lit - Power On, Unlit - Power Off
Blinking - when registration, Initialisation or upgrade
process is active.
Yellow LED
†
Lit - Common fault at module, Unlit - No fault
59