Battery Installation - Honeywell Notifier INSPIRE E10 Installation Instructions Manual

Battery installation

Battery installation
The YUASA 12V NP series batteries are recommended for Notifier INSPIRE E10 and E15 panel range. The E10
panel enclosure can accommodate 12Ah and 24Ah batteries, while the E15 panel enclosure can additionally
accommodate 38 Ah batteries. Note the 12 Ah battery have faston tabs for terminals for battery cable connection.
Insert the Battery strap
and place the plastic ring over the hook
orientation shown and place them inside the backbox, ensure they are seated far back into the enclosure. Route
the battery strap over the batteries with 'Velcro' side outwards and insert it through the slot in the left bracket
and pull the orange tab over the batteries and secure it to the velcro



70

in through a slot on the right bracket with the 'Velcro' side facing inside the backbox

. Move the battery leads
25A

Fuse



away and take the two batteries

.

2 x 12V 24 Ah

2 x 12 V 24 Ah

in the
The batteries used within this product
may only be replaced by batteries that
are in compliance with IEC 60896-11,
IEC 60896-21 and IEC 60896-22,
IEC 61056-1 and IEC 61056-2 or
IEC 62485-2 and made of material
with ammability rating V-1 or better.
-
+

