Tray Descend Amount - Formax FD 3302 Operator's Manual

Chapter 3 Advanced Operation
9-8.

Tray descend amount

You can specify the descend amount of paper feed tray when pressing the@ key during paper feed or
operations.
I
7 I
II
Touch the
key-> Touch [Tray Desc Amount].
The [Tray Desc Amount] screen is displayed.
No. Name
l
Tray Desc Amount
[1
It is recommended to set the paper feed tray descent distance to [Large]. When the descend distance is
decreased by selecting [Not Descend] or [Small], paper may be put on the paper detection sensor depending
on paper thickness or paper stack height, double-feed may occur when paper is put on the sensor and re­
fed.
If you have decreased the tray descend amount, remove paper on the paper feed tray and load it again, then
feed paper.
When there is no paper on the paper feed tray, [Large] is selected regardless of the setting.
72
key on the [Ready] screen-> Touch the� key-> Touch the
0
Not Descend
0
Normal
l!I
0
Tray Desc Amount
[Large]: descends to the lower limit.
[Normal]: descends about 30 mm/1 .18 inches from the paper
feed tray stop position.
[Small]: descends about 20 mm/0.79 inch from the paper
feed tray stop position.
[Not Descend]: remains at the paper feed tray stop position.
110
Small
LJ@
I
Large
131
Function
[E]
l
[1
Default
value
Large