Formax FD 3302 Operator's Manual page 30

Chapter 1 Before Operation
No. Name
[4] Folding A setting
[5] Folding B setting
[6]
(Folding mode selection)
key
[7] Finishing length
[8]
(Cancel) key
[9]
(Save) key
[10]
(Return) key
[11] Side X setting
[12] Side Y value display
24
Displays currently set folding A length.
When the key is touched, the [Edit] screen of folding A is displayed.
Setting range: 42.0 to *** mm/ 1.65 to *** inch
***: 442.0 mm/17.40 inches or "Paper length + 5.0 mm/+0.197 inch",
whichever is shorter.
Displays the currently set folding B length.
When the key is touched, the [Edit] screen of folding B is displayed.
When folding B is not used, set as 0.0 mm.
Setting range: 0.0/47.0 to *** mm/ 1.85 to *** inches
***: 223.0 mm/8.78 inches or "paper length + 5.0 mm/+0.197 inch",
whichever is shorter.
When the key is touched, the [Folding Mode] screen is displayed.
When folding mode is set, value of the folding A and folding B is input
automatically according to the paper size and folding form, and display
returns to this screen.
Displays the estimated value of the finishing length based on the input
value and folding form.
When [Slct FIN Size] is selected, the numerical values that were input in the
finishing size input screen are displayed.
When you enter this screen from the [Basic Settings] screen, the display
returns to the [Paper Length] input screen. In this case, the values of folding
A and folding B that you have input are temporarily saved, and the values
are restored when you save the paper length.
When you touch the
however, the temporarily stored values are discarded.
Press and hold to return to the [Ready] screen.
When [Slct FIN Size] is selected, the display returns to the F position setting
screen.
Saves the input value and displays the [Save] screen.
When the combination of input values is in the following conditions, the
data becomes invalid and cannot be saved.
- The value of folding A is set to [0].
- Folding A is larger than L (the paper length).
- Folding B is larger than both folding A and "L - folding A".
Saves the input value and returns to the [Ready] screen.
The input value is not saved.
Displays the length of side X currently being set.
When the key is touched, the side X input screen is displayed.
When the folding type is set to deformed single fold, the length of side X is
automatically determined and cannot be edited.
Displays the automatically calculated length of side Y.
This cannot be edited.
Function
key on the [Paper Length] input screen,