Detaching And Refitting The Heat Roller Separation Claws - Olivetti d-Copia 2500MF Service Manual

2H0/2HZ

(2) Detaching and refitting the heat roller separation claws

Follow the procedure below to replace the heat roller separation claws.
Procedure
1. Remove the fuser heater (see page 1-5-45).
2. Remove four screws.
3. Remove four claws and remove the rear
fuser guide.
4. Remove the spring and remove the heat
roller separation claws.
5. Replace the heat roller separation claws and
install the claws.
6. Refit all the removed parts.
1-5-42
Rear fuser guide
Claw
Claw
Screw
Heat roller
separation claw
Spring
Service Manual
Claw
Screw
Screw
Figure 1-5-77
Figure 1-5-78
Claw
Screw
Y108620-5