2H0/2HZ
4. Remove four screws and remove the HDD
mount.
5. Replace the hard disk and Install the hard
disk.
6. Refit all the removed parts.
7. When the hard disk is replaced, perform
maintenance mode U024 to initialize the
hard disk (see page 1-3-17).
When the fax backup kit is installed, perform the
following procedures (see page 1-3-79 ).
1. Run maintenance item U933 and press
[FAX IMAGE] to print out the FAX image.
2. Run maintenance item U933 and press
[JOB ACCOUNTING] to restore the job
accounting data to the hard disk.
3. Run maintenance item U933 and press
[INITIALIZE CF] to initialize the fax backup
kit.
1-5-58
Hard disk
Screw
Screw
Service Manual
Screw
HDD mount
Figure 1-5-104
Screw
Y108620-5