Code
C8030
Tray upper limit detection problem
(optional document finisher)
When the tray elevation motor raises a
tray, the ON status of the tray upper limit
sensor is detected.
C8140
Tray elevation motor problem
(optional document finisher)
When the tray elevation motor is driving,
the ON status of the tray lower limit sen-
sor or surface view sensor cannot be
detected even if 10 s passed.
Y108620-5
Contents
Causes
The tray upper limit
Reinsert the connector. Also check for conti-
sensor/push paper
nuity within the connector cable. If none,
sensor/surface
remedy or replace the cable.
view sensor con-
nector makes poor
contact.
Defective tray
Replace the sensor.
upper limit sensor/
push paper sensor/
surface view sen-
sor.
Defective finisher
Replace the finisher main PWB and check
main PWB.
for correct operation.
The tray elevation
Reinsert the connector. Also check for conti-
motor connector
nuity within the connector cable. If none,
makes poor con-
remedy or replace the cable.
tact.
The tray elevation
Replace the tray elevation motor.
motor malfunc-
tions.
The tray lower limit
Reinsert the connector. Also check for conti-
sensor/push paper
nuity within the connector cable. If none,
sensor/surface
remedy or replace the cable.
view sensor con-
nector makes poor
contact.
Defective tray
Replace the sensor.
lower limit sensor/
push paper sensor/
surface view sen-
sor.
Defective finisher
Replace the finisher main PWB and check
main PWB.
for correct operation.
Service Manual
Remarks
Check procedures/corrective measures
2H0/2HZ
1-4-27