Olivetti d-Copia 2500MF Service Manual page 70

2H0/2HZ
Maintenance
item No.
Adjusting the DP input light luminosity
U074
Description
Adjusts the luminosity of the exposure lamp for scanning originals from the DP.
Purpose
Used if the exposure amount differs significantly between when scanning an original on the platen and when
scanning an original from the DP.
Setting
1. Press the start key.
2. Select the item to be set.
Display
R
G
B
K
3. Change the setting using the +/- or numeric keys.
Increasing the setting makes the luminosity higher, and decreasing it makes the luminosity lower.
4. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in interrupt copying mode
(which is activated by pressing the system menu key).
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the economy mode
U080
Description
Sets the level in the economy mode.
Purpose
To increase or decrease the image density in the eco-print mode.
Setting
1. Press the start key.
2. Select [ADJUST DATA].
Description
Exposure is toner economy mode
3. Change the setting value using the +/- or numeric keys.
Increasing the setting makes the image darker; decreasing it makes the image lighter.
4. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in interrupt copying mode
(which is activated by pressing the system menu key).
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-36
Description
Description
DP input light luminosity of R image
DP input light luminosity of G image
DP input light luminosity of B image
DP input light luminosity of K image
Service Manual
Setting
range
-12 to 12
-12 to 12
-12 to 12
-12 to 12
Setting range Initial setting
-12 to 0 -6
Initial
setting
0
0
0
0
Y108620-5