Liners - Valor LX2 CORNER Installation Manual

Installation

Liners

Ceramic Liners: The ceramic liner panels consist of
three rear sections in one carton and one end panel in a
separate carton. The three sections are fi tted into each
other. Two of the sections are identical. Their step edges
go towards the middle to fi t into the middle section.
Ceramic liner panel sections—top view
Glass Liners: The glass liner panels consist of three
identical rear sections in one carton and one end panel
in a separate carton.
The Glass Liners install in the same manner and order
as the ceramic panels; however they don't fi t into each
other. They sit beside each other
Installation
1. Unpack the liner panels carefully.
2. Remove the rear media tray (3 screws).
34
3. Inside the fi rebox, at the rear of the top panel, and
on the closed side of the fi rebox, release the screw
of the 4 panel supports and slide the supports to-
wards the middle of the fi rebox.
4. Place the end panel, notch at the top, against the
side wall of the fi rebox and rest it on the ledge. Slide
the panel towards the front of the fi rebox.
5. Place one rear end panel, top fi rst, against the back
wall of the fi rebox, square edge outward and step
edge in the center. Slide the panel outward so it is
held behind the mounting support.
step edge
in center
Liners
behind
support