Table of Contents
Advertisement
Installation
The liners install in the manner outlined below with the
exception of the 1525RGL—Refl ective Glass Liners:
see instructions supplied with the liners.
Unpack the liner panels carefully.
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors just enough to
allow them to rotate (one per side).
2. Remove the top panel support located in the center
of the fi rebox at the top edge (2 screws).
3. Place the rear panel, beveled edge on top, on the
ledge above the ports of the rear of the fi rebox. The
panel sits on the ledge behind the tabs.
4. Place the left
panel against the
left wall of the
fi rebox.
5. Place the right panel against the right wall.
6. Tighten the side panel anchors on each side.
7. Insert the top panel, bevel on top,
over top of one of the side panels;
push it in the place the rest of the
panel on top of the other side and
rear panels. Center it.
NOTE: If the space is too tight, the
top panel can be installed before the
right panel. In this case, install the right panel last.
8. Reinstall the top panel support (2 screws).
Liners
top
underside
(fi re side)
39
Advertisement
Table of Contents
