Liners - Valor 2200KN Installation Manual

Installation

Liners

Ceramic Liners: The ceramic liner panels consist of
three sections which are fi tted into each other. Two of
the sections are identical. Their step edges go towards
the middle to fi t into the middle section.
Ceramic liner panel sections—top view
Glass Liners: The glass liner panels consist of three
identical sections.
The Glass Liners install in the same manner and order
as the ceramic panels; however they don't fi t into each
other. They sit beside each other
Installation
1. Unpack the liner panels carefully.
2. Remove the rear media tray (3 screws).
34
3. Inside the fi rebox, at the rear of the top panel,
release the screw of the 3 panel supports and slide
the supports towards you.
4. Place one end panel, top fi rst, against the back wall
of the fi rebox, square edge outward and step edge
in the center. Slide the panel outward so it is held
behind the mounting support.
step edge
in center
5. Repeat with the other end panel.
6. Fit the center panel with its step edges overlapping
both end panels.
Liners
behind
support