Daikin Madoka BRC1H82K Installer And User Manual page 55

Cooling
Heating
BRC1H82W+K+S
Madoka wired remote controller
4P596268-1A – 2022.02
INFORMATION
When operation modes are not available in the operation mode menu, it is
additionally possible that they are locked. The locking of operation modes occurs
through the Madoka Assistant app. For more information, see the Madoka Assistant
app and "Function
INFORMATION
If the operation mode changeover of an indoor unit is under centralised control
('changeover under centralised control' status icon blinking in the home screen),
then it is NOT possible to change the operation mode of that indoor unit. For more
information, see
If the outdoor air temperature is high, it can take some time until the indoor room
temperature reaches the setpoint temperature.
When the indoor room temperature is low, and the indoor unit is set to run in
Cooling operation mode, the indoor unit can enter Defrost operation mode first
(i.e. Heating operation), this to prevent a decrease of the system's cooling capacity
due to frost on the heat exchanger. For more information, see "Heating" [
The indoor unit can run in Cooling operation mode because it is operating under
Setback conditions. For more information, see "Setback" [
When running in Heating operation mode, the system requires a longer time to
reach the setpoint temperature than when running in Cooling operation mode. To
make up for this, it is recommended to let the system start operation in advance by
making use of the timer function.
The indoor unit can run in Heating operation mode because it is operating under
Setback conditions. For more information, see "Setback" [
To prevent cold drafts and a reduction of the system's heating capacity, the system
can run in the following special heating operation modes:
Operation
Defrost
Hot start (VRV only)
4
lock" [ 113].
"Cooling/Heating masterhood" [
To prevent the loss of heating capacity
due to frost accumulation in the outdoor
unit, the system will automatically
switch to defrost operation.
During defrost operation, the indoor
unit fan will stop operation, and the
following icon will appear on the home
screen:
The system will resume normal
operation after approximately 6 to 8
minutes.
During hot start, the indoor unit fan will
stop operation, and the following icon
will appear on the home screen:
13 Operation
|
4
86].
4
4
110].
4
110].
Description
Installer and user reference guide
55].
55