Daikin Madoka BRC1H82K Installer And User Manual page 105

Status indicator
Date and time
About
Remove bonding information
BRC1H82W+K+S
Madoka wired remote controller
4P596268-1A – 2022.02
To enable this visualisation, set the appropriate remote controller field setting to 1
(Mode R2 – SW 7). See
information about the remote controller field settings and the setting procedure.
INFORMATION
In case the remote controller only displays a blank CO
whether the unit equipped with the CO
In the Madoka Assistant app (Unit settings > Maintenance > Unit number) change the
unit number of the unit equipped with the CO
connected units.
Make remote controller status indicator settings:
Settings
Mode
Intensity
Set the remote controller date and time. In the date and time menu you send date
and time information to the remote controller from the app. You can choose to
either send the date and time information of your mobile device ("Synchronise
with device date and time"), or to manually create and send date and time
information.
INFORMATION
If the controller is disconnected from the power for more than 48 hours, the date
and the time need to be set again.
INFORMATION
The clock will maintain accuracy to within 30 seconds/month.
Read out the current remote controller and remote controller Bluetooth module
software version.
Make the controller forget all previously bonded mobile devices.
"Remote controller field
sensor has the lowest unit number.
2
2
Check the active status indicator mode.
It is not possible to set the status
indicator mode from the app; this
happens through remote controller field
setting R1-11. For more information, see
"Remote controller field
Set status indicator intensity.
15 About the app
|
4
settings" [ 75] for more
concentration value, check
2
sensor to the lowest number of all
Description
settings" [
Installer and user reference guide
4
75].
105