Table of Contents
Advertisement
Front bezel security
The front bezel can be locked in place by installing a security screw provided by HP. To install the security
screw:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
If you do not have a 6-32 standard screw, remove one of the four silver 6-32 standard screws located on
top of the drive cage. Refer to
standard screw locations.
4.
Install the 6-32 security screw through the middle front bezel release tab to secure the front bezel in
place.
20
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page
19).
Installing and Removing Drives on page 33
18).
for an illustration of the 6-32
Advertisement
Table of Contents
