Table of Contents
Advertisement
Table 5-3
Computer Setup—Advanced (for advanced users) (continued)
Option
Built-In Device Options
Port Options
74
Chapter 5 Computer Setup (F10) Utility
Heading
●
Previous state—causes the computer to power on automatically as soon as power is restored, if it
was on when power was lost.
SVM CPU VIrtualization (enable/disable)
Controls the virtualization features of the processor. Changing this setting requires turning the computer
off and then back on. Default is disabled.
Allow PCIe/PCI SERR# Interrupt (enable/disable)
Allows PCI devices to report PCI/PCIe System Error signals, such as address parity errors, data parity
errors, and critical errors other than parity. Default is enabled.
Power Button Override (disable/4 sec/15 sec)
Lets you disable or enable and select the number of seconds you have to hold down the power button for
it to override the system. Default is '4 sec'.
Embedded LAN Controller
Select to show the device in the operating system. Default is enabled.
Wake On LAN
Lets you either disable the Wake On LAN feature, or configure where the computer boots, including the
network or hard drive. Default is Boot to Network.
Embedded WWAN Device
Select to enable.
Video Memory Size
Use this option to manage graphics memory allocation. The value you choose is allocated permanently to
graphics and is unavailable to the operating system. For example, if you set this value to 512M on a
system with 2 GB of RAM, the system always allocates 512 MB for graphics and the other 1.5 GB for use by
the BIOS and operating system. Default is 'Auto' which sets memory allocation to 512 MB.
Audio Device
Select to show the device in the operating system. Default is enabled.
Internal Speakers (does not affect external speakers)
Select to show the device in the operating system. Default is enabled.
Integrated Microphone
Select to show the device in the operating system. Default is enabled.
Integrated Camera
Use this option to disable the integrated video controller when another video controller is present in the
system. Default is enabled.
Increase Idle Fan Speed(%)
Sets idle fan speed percentage. This setting only changes the minimum fan speed. The fan is still
automatically controlled.
Fingerprint Device
Select to show the device in the operating system. Default is enabled.
Touch Panel
Select to show the device in the operating system. Default is enabled.
Allows you to hide the following ports from the operating system:
Advertisement
Table of Contents
