Table of Contents
Advertisement
Hood lock
The hood lock is attached to the rear of the chassis.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
On the rear of the computer, remove the security screw that secures the lock.
NOTE:
4.
From the inside of the computer, disconnect the cable from the system board (1), and then lift the hood
lock out of the computer (2).
To install the hood lock, reverse the removal procedure.
When installing the hood lock, on the inside rear of the computer, insert the clips on the back of the lock into
the slots on the computer rear panel (1), and then rotate the lock down into place (2).
50
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
The security screw requires a special security wrench to remove.
(Preparation for disassembly on page
19).
18).
Advertisement
Table of Contents
