Installing A 2.5-Inch Hard Drive - HP EliteDesk 705 G3 Small Form Factor Maintenance And Service Manual

Installing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Install four black and blue M3 isolation mounting guide screws (two on each side of the drive).
NOTE:
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
4. Rotate the drive cage to its upright position.
44 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
M3 metric isolation mounting guide screws can be purchased from HP.
(Preparation for disassembly on page
19).
18).