Dust Filter - HP EliteDesk 705 G3 Small Form Factor Maintenance And Service Manual

Table of Contents

Advertisement

Dust filter

Some models are equipped with a front bezel that includes a dust filter. You must periodically clean the dust
filter so that the dust collected on the filter does not impede air flow through the computer.
NOTE:
The optional dust filter front bezel is available from HP.
To clean the dust filter:
1.
Remove the access panel
2.
Remove the front bezel
3.
To remove the dust filter access panel, press the right side of the filter access panel on the main bezel
(1), rotate the right side of the filter access panel off the main bezel (2), and then pull the left side of the
filter access panel out of the main bezel (3).
4.
To remove the dust filter, lift the two separated ends of the filter (1), and then pull the filter off the filter
access panel (2).
22
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
(Access panel on page
19).
(Front bezel on page
19).

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EliteDesk 705 G3 Small Form Factor and is the answer not in the manual?

Table of Contents

Save PDF