Power Off The Device; What's Next - Cisco Firepower 2100 Series Getting Started Manual

Firepower Threat Defense Deployment with FDM
Note

Power Off the Device

It's important that you shut down your system properly using FDM. Simply unplugging the power or pressing
the power switch can cause serious file system damage. Remember that there are many processes running in
the background all the time, and unplugging or shutting off the power does not allow the graceful shutdown
of your Firepower system.
Procedure
Step 1
(6.5 and later) Use FDM to shut down the device.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3
After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.

What's Next?

To continue configuring your FTD device, see the documents available for your software version at
the Cisco Firepower
For information related to using FDM, see
Device
This returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?. For usage information, see the
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Documentation.
Manager.
Cisco Firepower FXOS Command
Cisco Firepower Threat Defense Configuration Guide for Firepower
Cisco Firepower 2100 Getting Started Guide
Power Off the Device
Reference.
Navigating
21