Exit Maintenance Mode; Drive R/W Diagnostic - ADIC LTO 200D User Manual

If the function is successfully completed,
Maintenance Mode.
If the function fails, the Status LED will flash amber, an error code will be shown on the single-character display, and
the drive exits Maintenance Mode. To resolve an error refer to Table 4-2 Error Codes, elsewhere in this chapter.
To clear an error, cycle (remove, then reapply) power to the LTO standalone.

Exit Maintenance Mode

To select the Exit Maintenance Mode function, perform the following steps:
1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.
The front panel indicators will display the following:
Indicator
Status LED
Single-character display
LCD
0
on the single-character display, press and hold the Unload button for three seconds to force the drive to exit
2. With
Maintenance Mode (the Status LED is solid green).
The drive also exits Maintenance Mode automatically after it has completed a function or after 10 minutes if no action
has occurred.

Drive R/W Diagnostic

Use this function to direct the drive to execute built-in tests to determine whether it can properly load and unload cartridges, and read and
write data.
To select the Drive R/W Diagnostic, perform the following steps:
1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.
Press the Unload button once per second until the front panel indicators display the following:
2.
Indicator
Status LED
Single-character display
LCD
If the function requires you to insert a cartridge, c will appear on the single-character
display. Within 60 seconds, insert a cartridge or the drive will exit Maintenance Mode.
If you insert an invalid or write-protected cartridge, a blinking 7 will appear on the
single-character display and the Status LED will be flashing amber and the LCD will
display ERROR! Media Error after the drive loads the tape. After several seconds the
drive will then unload the cartridge and exit Maintenance Mode.
State, Character, or Message
Maint Mode: Select
Exit Maint Mode
State, Character, or Message
Maint Mode: Select
Drive R/W Diagnostic
Notes
0
appears temporarily on the single-character display and the drive exits
Amber, solid
0
Amber, solid
1
Troubleshooting and Diagnostics 27